Technical & Certification
Technical information & certification
This page sets out what we can state today, and what must be confirmed for your specific supply. We keep the distinction explicit on purpose.
What we confirm per project
- Product family, geometry and panel or roll dimensions against your drawings.
- Wire diameter and coating type applicable to the supply offered.
- Mill certificates and material traceability for the delivered batch.
- Available test reports and declarations of performance for the offered product.
- Packing, marking and export documentation for the destination market.
What is not yet confirmed
- Double-twisted steel mesh dimensional and mechanical specifications are shown on this website as generic industry reference ranges only, pending confirmation from our supply chain.
- Energy classification of ring net systems depends on the complete assembled system (net, ropes, brake elements, posts and anchors), not on the net alone.
- Any CE marking, ETA, EAD or national approval reference applies to a specific product from a specific manufacturing plant and must be verified for the offered supply.
- Coating class and expected service life depend on the environment and are stated only after the exposure conditions are known.
Reference frameworks
The following frameworks are commonly referenced in this sector. Their applicability to a given supply is confirmed case by case; listing them here is not a claim of certification.
- EAD 340059-00-0106 / ETAG 027 — falling rock protection kits (system-level assessment).
- EN 10218 / EN 10223 series — steel wire and wire products for fencing and mesh.
- EN 10244 series — non-ferrous metallic coatings on steel wire.
- EN ISO 1461 / EN 10245 — coating and polymer coating requirements where applicable.
- Project-specific national codes and tender specifications supplied by the client.
Documentation issued with a supply
- Quotation with confirmed technical schedule
- Mill / material certificates
- Coating certificates where applicable
- Available third-party test reports
- Packing list and shipping documentation
Specification note
Figures shown are indicative reference values for pre-design and budgeting only. Exact dimensions, wire grades, coating classes and mechanical performance are confirmed in writing, per production batch and per project, before order confirmation.
Certification note
Certification, CE marking and third-party test coverage vary by product line, production plant and destination market. We supply the applicable declarations of performance, mill certificates and test reports for the specific supply on request. No certification claim should be relied upon until it has been confirmed in writing for your project.